a Virtual Robotix Network Team

Hardware Platform (36)

Discussions Replies Latest Activity

Olimex Jtag connections to MP32?

Does anyone have a proven pin-to-pin connection diagram for the Olimex 20pin to MP32 Arm 10 pin connector. In otherwords, what pins on the…

Started by Jim Tompkins

0 Apr 2, 2011

MP32 noise when input power is low

I had a 450mA 2s lipo powering the MP32 today while I was scoping, setting up, and testing the ppm encoder and a few various receivers (try…

Started by Jim Tompkins

1 Mar 27, 2011
Reply by Roberto Navoni

Oilpan not putting MP32 into run mode

With the Oilpan connected, the MP32 is not going into run mode. Boot_0 (JP11-5) is staying high. Without the Oilpan installed (jumper betwe…

Started by Jim Tompkins

7 Mar 25, 2011
Reply by Roberto Navoni

Hardware for aircraft with restricted space

Hi,   I am flying sailplanes that do not have much space. It would be good to have hardware that would fit in this restricted space. Are th…

Started by Matthew Coleman

8 Mar 1, 2011
Reply by Matthew Coleman

Open Source Brushless Controller ArduESC 1.0A 20 AMP I need help in the project

Dear Friends, two years ago i developed a closed source Brushless Controller. It's based on ATmega 8 and support i2c,PWM,Serial Port. T…

Started by Roberto Navoni

9 Feb 1, 2011
Reply by Elie T

Future electronics development

Open debate of how should we continue with future electronics. Do we still continue with ATMega644 based boards or ARM based or even AtXMeg…

Started by Jani Hirvinen

1 Jun 12, 2010
Reply by Roberto Navoni



© 2020   Created by Roberto Navoni.   Powered by

Badges  |  Report an Issue  |  Terms of Service