I'm currently hooking up my Vrbrain to my new hexa (1.10meter home made CF hexacopter, i'll post the files and solidworks as soon as possible for everyone to be able to make them), and i have two questions:
- First of all, is that normal that when i connect my board to Mission planner (using the usb cable, i need to buy a telemetry kit), it doesn't show up that my GPS is connected (it says GPS: no gps)?
- Secondary, i'm using a 5S lipo on this hexa. I saw in the "Vrbrain bible" that is was the max allowed, so that's perfect, but do you know if the hardware is protected from the high voltage produced when connecting the batteries to the hexa? (i just took the voltage mesurement on my distribution board, and wouldn't like to fry the chip connecting my lipos...
so about the gps .. no gps is not correct what kind of gps are you using and what firmware do you use ?
Internal or external ?
The vrbrain support only 5 volt from bec on header , but on point for control vbatt can read untill 6S without problem .. so you need a bec between the lipo battery and vrbrain pin header .. can you explain how you are connecting the battery to vrbrain ?
I Nicolas ,
the ublox gps work fine with VRBrain , normally no problem ... consider that in rev 3.0 you need to connect gps to telemetry port and vice versa. The external gps firmware is correct revision. It's ok !
About lipo voltage control we don't have problem until 6s lipo ...
The circuit is protect by a diode.
ok to i can't use the GPS port anymore? That stinks..
Ok perfect if the circuit it's protected! i just didn't wanted to burn everything up when connecting my lipo :)
I have a VRBrain 4.5 and a 3DR Ublock GPS,
With Internal GPS firmware, you can use your GPS in the white GPS plug directly on the VRBrain card. You just have to open a hole in the box to insert your plug.
I just bought a VRbrain and compass/GPS (it came with the 3DR unit which include both GPS and compass)
Now i tried to find how to connect this 3dr unit along with 3dr 433 telemetry.
It is not clear how to connect?
Tried to find a complete pinout for the small connectors thats on the vbrain board, is there a picture which explain ALL pins not only the input/output pins?
I worked out where to connect the GPS on the sidepins marked "MAVLINK" on the pictures avalible, but where to connect the 3dr telemetry when the "MAVLINK" is occupied with the GPS?
There is some info there:
I have GPS (without compass) plugged on the White GPS plug of the board (internal gps). For the compass, you should look in the forum and news to find the wiring diagram.
For Telemetry, Use RX and TX right upper pins and use Lower for Ground and Middle for +5v.
I have it work now, thanks