May 2011 Blog Posts (5)

Dear Friends,

this month we have a lot of news and update on MP32 board and project :

http://www.virtualrobotix.com/page/multipilot32-1

This is a fly of Ardupirates32 NG for Gaui 300XS : frame , esc motors and propellers.

1) VRIDE 0.0.4 is available :…

Not sure if I have installed this correctly - I had errors when decompressing the archive although it seems to have installed ok.

When it is run it gives a series of Out of Range Exception errors for value 0 not being vaolid. Any suggestions?

Peter

The project is about controlling digital cameras remotely using USB PTP commands and adding telemetry and camera feedback data to the video signal coming from the controlled camera. The main purpose is to be applied on UAV projects, otherwise, it can be used on every kind of camera remote controlling and shooting.

The hardware used here allows some nice extrapolations of the project. Let's say you could use the USB Host to attach another kind of peripheral like a…

In this video you can see the first flight doing with Virtual Robotix IMU , in the test i only check the sensor board , Gyro and Accelerometer , in the next test i check navy and input output functionality.

Today was a windy day , after solve with Randy a problem on the YAW control .. i doing the preflight check , all seem to work fine and so decide to going in the sky.

I'm using the same PID used with oilpan , there're not…

Dear Friends,

in last month we're some great news from FoxTeam and Virtualrobotix community.

We are doing our first Gps hold , Altitude hold test.

http://www.virtualrobotix.com/profiles/blogs/armfox-v4-gps-and-altitude

Some user start to fly with his quad based on Multipilot32 with Ready to Fly firmware and hardware setup

With standard…