While waiting on the CTX4 V2 CNC work to be done, I have started a new project CX4M (a mini quad). I have finished the CX4M design. Next step is to get someone to do the CNC part (1,5mm carbone). The CTX4 V2 parts have arrived, so I can start working on that frame while waiting.
My CX4M setup:
Frame: 25-26 cm motor – motor (1,5mm carbone)
Motors: Turnigy Multistar 1900Kv
ESC: Afro 12A
Prop: 5x4.5x3
Controller: VRBRAIN (of course) + Ublox lea 6 GPS
LiPo: Zippy Compact 1000mAh 35C 3S
Camera: Mobius (HD recording + FPV)
FPV TX: 200mW 5,8Ghz
CTX4 V2 = C:Carbone T:Tube X:quad type 4:quad
CX4M = C:Carbone X:Quad type 4:Quad M:Mini
CTX4 V2 (right)
CX4M center plates (left) - The arm design was not ready when this CNC work was done.
Comments