Forum

Replies

  • Cyrille November 25, 2011 at 12:09pm

    Hi Roberto,

    Could you indicate a reference for the micro SD socket of MP32 (there are many ref with different footprint)?

    Thanks

    Cyrille

     

    • Jan Vervoorst > Cyrille February 1, 2012 at 8:27am

      I'm sure Roberto won't mind if I publish this information. Here are the different micro sd card sockets that fit on the MP32 boards:

      Kyocera 04 5138 008 010 890+

         Digikey : 478-4965-1-ND
         Farnell: 1558178
         Mouser: 581-045138008010890+

      For the MP32v3 boards, another socket can also be used:

      Amphenol 114-00841-68
         Digikey: 114-00841-68-1-ND
         Farnell: 1788488

    • Roberto Navoni > Cyrille November 26, 2011 at 5:28am

      Hi Cyrille,

      send a mail to d.ambroggi@radionav.it is a member of LaserNavigation technical stuff that know the exact code of that component.

      Best

      Roberto

  • Arashi Tohwa March 27, 2011 at 12:06am
    Thank you for the reply.

    I just found the answer on your instruction page, I just didn't read far enough.

    * Micro SD card is not yet supported hardware connector is an option , is possible to buy it and solder on board , the firmware support will be available in the next months.

    Thanks

    Arashi
  • Roberto Navoni March 26, 2011 at 11:19pm

    Hi Arashi,

    I'm working on firmware to support the micro SD using SPI2 , at the moment is possible to mount card socket as option , but normally is not installed on the board is available only as an option. The socket is available on Digikey or other hardware supply , If you need to start to test this feature is possible to try chibiOS implementation , tomorrow i can send to you the code .

    Best Roberto

This reply was deleted.