Compared to the NiCd and NiMH, Lipo batteries are commonly used in the industry of radio control models on account of the higher performance, efficiency, friendly environment and so on. The rechargeable lipo widely applies to remote controlled cars,Read more…
Ovonic is a new brand on the market but is really a budget choice for you if you are flying practice. Thanks to most of the Ovonic battery for FPV under the $20, so it doesn't need you to cost an arm and leg. now, let's see some review from Ovonic fpRead more…
I would like to share some information about my fresh project made in moulds. The gimbal weight is 520 g with 1000 mAh LiPo. The main shaft for roll have 8 mm diameter, the stator of motor (∅40/12) 18 teeth with 24 magnets.
In the top LiPoRead more…
Xiaomi Mi drone 4K, is produced by a Chinese technology company which named Xiuaomi; Xiaomi mi drone 4K is an easy to learn, high resolution videos, safe and convenient 4K camera WIFI quadcopter, it is very suitable for beginners. As we know, XiaomiRead more…
investigations are intended to determine whether operators violated FAA safety regulations.Read more…
Tattu has been an active member of the miniquad community since the early days, but this is their first foray into the motor world. Tattu 2305 2450KV motors are made for FPV Racing drone. This drone motors are mainly suitable for 180-250mm quadcopteRead more…
after some time of evaluation of software architecture for Multipilot32 I decide to put on it a Real Time Operating Systems.
Instead of choose FreeRtos or other clone . I found this interesting operating system that yet support HAL .
Today I had my second test flight with the latest Firmware.
The Board tested was the VRIMUFULL with the MP32V3F1 and the BMP085 barometer.
Recent changes include:
- Updated default values for Stabilization
- Changed main loop timing.
- Fixed a memo
Hello, I have the MP32 F1 with the VRIMU navi board and I have software version 2.0.49. I was trying to upload last available version 2.22xp2 PIDT1 but no success.
1 - I downloaded the vr ide 0.0.5.4.0 and unzipped
2 . Downloaded the 2.22xp2PIDT1 firRead more…
Basic ArduPiratesNG32 PreFlight Check.
- Pre Requisite .
- Configure your Radio.
- Compile and Upload the firmware.
- Setup your Drone.
- Pre Flight Check on your prefer Arducopter Configurator.
- Check your sensor.
- Check Radio.
- Connect ESC and Motor.
Good dear friends!
From the first moment I bought the VR Bain 5.2, I have not been able to put to work the 3DR Power Module to display the current consumption and another problem is Powering the board with internal regulator, this does not work.
If anybody is interested to ge an amazing VR Gimbal a little bit cheaper. I am selling my used one. I flew 2 times with it. Due to problems with my quad i am selling it.Read more…
Note: this page contains paid content.
Please, subscribe to get an access.