Forum

Open Source Brushless Controller ArduESC 1.0A 20 AMP I need help in the project

Posted by Roberto Navoni on January 13, 2011 at 10:20am in Hardware Platform

Dear Friends,

two years ago i developed a closed source Brushless Controller. It's based on ATmega 8 and support i2c,PWM,Serial Port. The ESC support until 20 Amp and the electronic is present a shunt resistor to evaluate the quantity of energy that the motor need in realtime.

So now I would to port a Arduino bootloader to this board and develop an opensoure code for it.

But i need help for this project ... There're some people that would join me in this project ? That's is good choice for Multipilot 2.0 / Ardupilot 32 platform.

Regards

Roberto

You need to be a member of FOXTEAM UAV CLAN to add comments!

Join FOXTEAM UAV CLAN

Email me when people reply –
Follow

Replies

  • Elie T January 30, 2011 at 5:45am

    Ciao Roberto,

     

    What kind of help do you need ?

     

    Regards,

     

    Elie T

     

    • Roberto Navoni > Elie T January 30, 2011 at 11:46am

      Hi Elie,

      my idea is to develop opensource firmware for a ESC that support i2c , serial , can bus .

      My idea is to support Brushless motor until 100 A

      Do you have some experience on this kind of systems ?

      Regards

      Roberto

  • Yadgarov Timur January 14, 2011 at 12:20am

    link

    http://www.rcgroups.com/forums/showthread.php?t=766589&highligh...

  • Yadgarov Timur January 13, 2011 at 11:06am

    its 4s 17V ?

    my opinion that this esc too large for 20A

    we look for turnigy plush i2c. becouse it cheaper then using OS esc

     

    please add more info about it, and if you can in next time add subtitles in video

    thanks

    • Roberto Navoni > Yadgarov Timur January 13, 2011 at 5:10pm

      Hi Yadgarov,

      thanks for your reply. During Week end i try to update the video and add subtitle :)

      Do you have some link of turnigy plush i2c so i can check it ? The idea of OS ESC is to can update pid and algoritmh of esc and add some feature as rate control of motor, temperature , realtime power comsumpion ecc.

      Regards

      Roberto

This reply was deleted.