LN MultiBoard ready for store.

[Roberto Navoni]

Hello everyone,

these are the first images of the cards will be available in stores are preparing.Multi Board cards were created to make aircraft and vehicles based on automatic technology Arduino.The basic software currently supported are:

• Aeroquad
• Arduimu.
• Arducopter.

The LN MultiBoard 1.0 board details :

• AVR 644P (Sanguino compatible micro)
• 1 Power Switching da 8-30 Volt 3 Amp.
• 3 mems gyroscope 220 °/s
• 1 Accelerometer a 3 Axis X Y Z 2 G.
• 2 Pressure sensor 20 cm of resolution.
• 4 PPM Output Servo PPM 5 Volt using 4017 TTL LOGIC.
• 2 PPM Ouptup using standard ServoTime2 / ServoTimer PWM Library.
• 1 I2C Bus for motor control( LN BL Controller 20 Amp.)
• 1 Serial BUS TTL
• 1 SPI BUS TTL
• 1 Speaker Output.
• 2 Digital Output genarl pourpose.
• 1 PPM Input for R/C Controller.

Details

visit the site of company that develop LN Multipilot 1.0 http://www.lasernavigation.it visit https://www.youtube.com/rnavoni to see LN Multipilot 1.0 in action. visit http://code.google.com/p/aeroquad/
I'm starting to support the project the goal is to port Aeroquad
firmware on MultiPilot

[Roberto Navoni]

Thanks Maximus,
actualy the MultiPilot Board is avaible and is possible to buy it . Actualy I'm working on eshop . The supported firmware is AQ 1.5 , AQ 2.0 Alpa and Arducopter Pre alpha.

[Maximus]

Hi, !
For the first time I can see intellingent creator that doesn't make I2C plots being only 1mm² !!!
Congratulations Robero !
Where can we test/buy this flight card and controllers ?
Cheers
Maximus di Francia ;)