Hello. Today I finally got my 6 mode flight switch working. I'm using a Futaba FT-T8UAP radio and I was having some troble selecting the switch to tamper with. Let me say thay the 2 or 3 position switches can't be replaced with a pot. I believe the electronics at the main board "recognize" them as switches and only allow max or min pwm (or center in case of 3 position switch). So I unsoldered a variable control potenciometer (ch 6) and replaced it with a 6 position selector. The selector with resistences can be acquired via ebay, at the following link (selector switch). This one already has resistors soldered, however if you want to buy just the selector switch without resistors, this is the link. If you're using a radio like mine, I had to adjust the resistors values as follows : (red +) -> 2.8k -> 1.5k -> 1.2k -> 1.2k -> 3.3k -> (black -). Hope this is of any help :)
You need to be a member of FOXTEAM UAV CLAN to add comments!
Replies