Hi,
I am working on getting my xbees connected to my ubrain. I have ordered some 2mm pitch header.
i understand all apart from the en pin, is this some sort of enable? is it an input or output of the ubrain?
how do I use it?
Cheers,
Stu
You need to be a member of FOXTEAM UAV CLAN to add comments!
Replies
Hi Stuart,
yes basically this bus is for standard SIK telemetry module but could work with a lot of different option.
Based on SILAB1000 micro controller .
https://github.com/tridge/SiK
It's compatible with 3DR and VRX telemetry module normally as option in europe it's available 433 and 868 module in the usa 915 mhz.
The CFG and Enable pin normally is used for going in program mode of module and EN is used for CTS check before to send new data on the air.
I think that xbee could be good for sworm application .
best
Roberto
Thanks for the info Roberto,
I'm not using mesh mode of the xbee, a swarm would be impressive though :)
Stu
OK I decided to just try connecting the basics to see if it wuld work,
so I wired
uBrain - XBee
3.3 to 3.3V
TX to Din
RX to Dout
GND to GND
and I have telemetry :)