Forum

Replies

  • emile June 3, 2012 at 11:24pm

    Generally speaking everything able to transmit serial data is compatible with the planner.

    I am using xbees at 2.4 GHz, only issue is that range is somehow a little short due to the interference with the radio and with sorrounding WiFis.

    Emile

    • Oyvind Amundsen > emile June 3, 2012 at 11:45pm

      Hi Emilie,

      What I ment was, if there are other telemetry rx/tx that ar compatible with the 3DR Radio settings panels in APM Planner. But i guess that the 3DR Radio have a special firmware..

      I did plan to order 3DR radios from diydrones, but they are out of stock.

      I hope the rx/tx set I ordered from eBay are ok

  • Oyvind Amundsen June 1, 2012 at 9:01pm

    Is this something that can be used:
    http://www.ebay.com/itm/Wall-Through-1200m-Wireless-Data-Transmissi...

    Tis module uses the Silicon Lab Si4432 cip (same as 3DR)

    Can operate on different bands: 433, 470,868,915 MHZ

    Output Power max 100mW

    • Oyvind Amundsen > Oyvind Amundsen June 3, 2012 at 7:06am
      I have ordered a set from ebay so I can test them with my MP32
  • Martin Posch June 1, 2012 at 11:44am

    I'm planning to try out APC220 Transparent Transceiver Module. I've bought 2 of them from exp-tech.de and plan to use it on ser3. however the baud rate is limited. The UART can handle up to 57600 but over the air only 19200 is possible according to the manual (http://www.exp-tech.de/service/pdf/APC220-43V1.3E.pdf).

    The question is, to which distance the 19200 work and if it is sufficient.

    regards

    Martin

This reply was deleted.