Forum

Posted by Oyvind Amundsen on December 18, 2011 at 5:11am in Hardware Platform

I´m planning my new quad/hexa frame to use with an MP32F4-IMU

1. Is it recommended to use vibration reduction mounts for the controller?

2. Is there a dwg file showing the mounting holes needed to mount the mp32fx controller?

You need to be a member of FOXTEAM UAV CLAN to add comments!

dwg, mounting, vibrations

Email me when people reply –

Oyvind Amundsen December 19, 2011 at 3:07am

(2) I did find the controller meshurements on this page, so then I have what I need to drill holes for the controller in my center plates.
Oyvind Amundsen December 18, 2011 at 11:48pm

I plan to use vibration reductions mounts like this (8/8mm, M3) soft rubber - 40SH
- Thomas Bredehorn > Oyvind Amundsen December 19, 2011 at 12:54am
  
  I've used the same for my MP32F1 board, so they should work nice for the F4 board too.

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.